How to make AU card

[admin]

Thanks to onuno

How to make an AU (AutoUpdate) Card

You need:
1 Working MK (00,01,04), SA or/and UA
2 AU hex-file
3 Editor for that file
4 A Card and programmer for it.

Follow that path:
1. Open AU-hex (eeprom-hex) with editor
2. Choose Provider
-if there aren’t, add provider ID, add provider name
3. Add keys 00, 01 and 04 to their places
-if you have key 08, put it to it’s place
4. Add SA to it’s place
-if there is a place for CUSTPW, put CUSTPW to it, or leave it as 00
5. Add UA to it’s place
(if you haven’t UA, you can try following;
-Write first two bytes 00, write SA, write CUSTPW(you can’t leave this as 00))
6. Save your hex-file
7. Select next provider, and repeat 3 –7 unless you have edited all needed providers
8 After you edited all providers, program your card

Now you have AU-card ready for use, put it into CAM.

AU: Tune the channel (provider) you want update. Reset! (turn receiver off/on with the channel you want updated, or pull out the card and put it in again)

Wait

If you had working mk/SA/UA your card will be updated after few minutes…..
Repeat process with every provider you edited…..

Have fun and enjoy the show……