Tere. Kui kanaleid vahetan viskab vahepeal sellise teksti no or bad signal ja kanal ei avane. Panen tüüneri korraks stan by`sse, siis avaneb.
Kas see on normaalne et teeb nii või ei ole?
Tüüner Humax 5400z. Kaks pead, astra ja hotbird. Kasutan Aljamri tohhi.
Kas probleem võib olla selles et, taldriku alumine äär asub lamekatuse pinnast 25 cm kõrgusel?
No or Bad Signal
Hakkan nüüd seda seedima.......
"No(or Bad) Signal" message on TV screen.
Check dish and LNB condition such as position.
Check connection of antenna and the STB.
If you are using DiSEqC, pls check the DiSEqC switching function works normally.
we have a request saying that the No or Bad signal problem was gone when changed the LNB.
If you are using a DiSEqC 1.0 switch, check that you have connected the LNBs to the correct connections on the switch Check the Tp information you entered is accurate.
Pls check the signal is good and covers your area.
In addition, other possible factor are temperature and tuner.
The temperature of a room or LNB can affect operation.
Check the current version and upgrade with the latest version only if the current version is out-of-date.
It is likely that the channels uploaded from PC have incorrect or slightly offset frequencies.
This can cause the receiver to take a few seconds before it locks onto the signal.
algmaterjal http://www.humaxdigital.com/hcsa/faq.asp#others_1
Tänud kõigile kes viitsisid kaasa mõelda.
"No(or Bad) Signal" message on TV screen.
Check dish and LNB condition such as position.
Check connection of antenna and the STB.
If you are using DiSEqC, pls check the DiSEqC switching function works normally.
we have a request saying that the No or Bad signal problem was gone when changed the LNB.
If you are using a DiSEqC 1.0 switch, check that you have connected the LNBs to the correct connections on the switch Check the Tp information you entered is accurate.
Pls check the signal is good and covers your area.
In addition, other possible factor are temperature and tuner.
The temperature of a room or LNB can affect operation.
Check the current version and upgrade with the latest version only if the current version is out-of-date.
It is likely that the channels uploaded from PC have incorrect or slightly offset frequencies.
This can cause the receiver to take a few seconds before it locks onto the signal.
algmaterjal http://www.humaxdigital.com/hcsa/faq.asp#others_1
Tänud kõigile kes viitsisid kaasa mõelda.