Digi-tv.ee

Lasin oma lollusest flashi tühjaks, seega USB-lt bootimine enam ei toimi.
USB–TTL konverter on olemas, aga ei tea täpselt, kus asuvad Uno 4K emaplaadil RX, TX ja GND pinid.

Kas keegi saaks jagada skeemi?

Googeldades
https://babcuvpisecek.com/diy/vu-solo-4 ... on-pinout/

äkki on abiks

kas üldse enam lootust kui tegin, flash_eraseall /dev/mtd0

See RJ12-kujuline pesa, mille all on kiri IR SENSOR / RS-232, tekitab palju segadust:
Mõnel vanemal Vu+ mudelil oli seal päris RS-232 (±12 V signaalidega), mida sai kasutada .nfi flashimiseks.
Uno 4K puhul see pesa EI OLE klassikaline RS-232, vaid pigem IR sensor / laiendus. Box ei väljasta sealt standardset serialit, mida saad otse PC COM-pordiga kasutada.
Uno 4K puhul töötab ainult emaplaadi sisemine UART päis (3.3 V TTL)

Vähemalt AI kirjutas nii

Pigem ootab ees emaplaadi vahetus või uus box.

Proovi
To undo a multiboot, search for "BPanther's Image".
https://www.linuxsat-support.com/thread ... ial-vu-4k/

I finally got it working with a similar error pattern, using "flash orgies." First, I tried the latest original VU image, then started with the oldest original VU image. I did this with and without "mkpart.update." However, I was sure the box in question wasn't multibooting. At some point, the menu button responded. I can't remember whether the installation wizard appeared beforehand. I then tested the box with the original VU image and then, after a few days, flashed the latest VTI image. The box does what it's supposed to do. However, it's entirely possible that there are defective clusters in the flash memory.
I have a Mipsel box; I have no idea if it will work for you with your ARM box.

USB-lt siis jutule ei võta?Kui võtab lase usb-ga uus bootloader peale seejärel originaalimage otsa